6 Inch and above
— FPS SR Series 6″
— FPS SR Series 8″
— FPS SSI Series 6″-8″-10″
— FPS STS Series
— FPS VSI Series
— FPS FS Series
— FPS FT – FC – FX Series
FPS STS Series
The FPS STS Series submersible water pumps were designed specifically for varied applications including Irrigation, Municipal, Industrial, Commercial and farm use where rugged ductile iron pump is required. These pumps contain premium ductile iron discharge and suction brackets and ductile iron bowls for longer life and higher pressures. Stainless upthrust bolt provides exceptional upthrust protection for the investment casting stainless steel impellers and polished 416 stainless steel pump shaft. Designed to operate efficiently with Franklin Electric submersible motors, the FPS STS Series Ductile Iron pump is equipped to handle the most demanding conditions.
- Ductile iron discharge and suction bracket
- Ductile iron bowls bolt together for easy service
- Stainless steel upthrust bolt provides exceptional upthrust protection
- Bronze discharge bearing is grease packed for maximum bearing protection
- Fluted rubber bearings in all bowls
- Suction inlet located above bottom bearing prevents abrasives from accessing the bearing
- Suction bracket design allows quick and simple access to coupling
- Bronze bracket bearing is protected with stainless steel sand collar
- Stainless steel impellers with stainless steel taper lock anchors impeller to shaft
- Stainless steel pump shaft for increased durability
- shaft coupling is keyed to pump by set screws and is splined to fit motor shaft
- 6” and 8” motor fit
- 4” discharge tapping BSPP for 6” pump, 4” and 6” discharge tapping BSPP for 8” pump
- Minimum submergence above pump inlet; 3.0 meters
